Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Accent Value Edition >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module & Sensors >> Front Impact Sensor (FIS) >> Repair Procedures >> Removal

Repair Procedures: Removal

CAUTION:
  • Removal of the airbag must be performed according to the precautions/procedures described previously.
  • Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Remove the front bumper.

    (Refer to "FRONT BUMPER ")

  3. Remove the washer reservoir.

    (Refer to FRONT WIPER MOTOR )

    [Right side only]

  4. Remove the front impact sensor mounting bolt (A).
    G12018120Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the front impact sensor connector (B).
  6. Remove the front impact sensor.
scientia non olet · About Mike's Workshop Manuals