Repair procedures: Replacement

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Be careful not to damage the fender and body.

Information

When removing the clips, use a clip remover.

Remove the head lamps.
(Refer to Body Electrical System - "HEAD LAMPS ")
Remove the side sill molding.
(Refer to Body Side Molding - "SIDE SILL MOLDING ")
Loosen the front wheel guard mounting clips and screws.

Fig 1: Loosening Front Wheel Guard Mounting Clips And Screws
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fender side repeater lamp (A).
Disconnect the fender side repeater lamp connector (B).

Fig 2: Disconnecting Fender Side Repeater Lamp Connector
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the delta garnish (A).

Fig 3: Removing Delta Garnish
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting clips, then remove the fender side cover (A).

Fig 4: Removing Fender Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, bolts, nut, then remove the fender assembly (A).

Fig 5: Removing Fender Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is plugged in properly.
- Replace any damaged clips.