Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Accent Value Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Body Control Module Diagnosis) >> DTC B1213-00: Front Right Sensor Fault >> Wiring Inspection >> LIN Communication Line Inspection

LIN Communication Line Inspection

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.

■ Inspection of LIN communication line between Front Left Side Sensor and BCM [PAS (Parking Assist System)] 

  1. Connect GDS and select "Oscilloscope"
  2. IG ON, ENG OFF and Shift lever D
  3. Set a stuff or obstacle near the Front Right Side Sensor.
  4. Measure a waveform of LIN communication line between Front Right Side Sensor and BCM [PAS (Parking Assist System)]

    Specification:  Refer to "SIGNAL WAVEFORM "

  5. Is measured value normal?

    YES 

    • Fault is intermittent caused by BCM [PAS (Parking Assist System)] DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.

    NO 

    • Check a circuit between Front Right Side Sensor and BCM [PAS (Parking Assist System)] and poor connection. And then repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.
scientia non olet · About Mike's Workshop Manuals