Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Accent Value Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Control System - 2.4L) >> Accelerator Position Sensor (APS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the upper mounting cap (B), and then remove the mounting nut (C).
  4. Remove the lower mounting cap (D), and then remove the mounting nut (E).
Fig 1: Removing Accelerator Position Sensor And Upper/Lower Mounting Cap
G12050994Courtesy of HYUNDAI MOTOR AMERICA
Fig 2: Disconnecting Accelerator Position Sensor Connector
G12050995Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals