Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2017 >> Accent Value Edition >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System/Electronic Stability Control System Diagnosis >> DTC C1260: Steering Angle Sensor Circuit-Signal >> Component Inspection >> Steering Angel Sensor Check

Steering Angel Sensor Check

  1. ENG "ON".
  2. Turn the steering wheel to the left or right.
  3. Measure waveform between signal terminal of the steering angle sensor harness connector and chassis ground with oscilloscope.

    Specification: 

    Check the voltage range(HIGH: 2.9±0.1V ~ 4.4±0.1V LOW: 1.2±0.1V ~ 2.1±0.1V) of the sensor signal in case of turning left, turning right, center position

    If normal waveforms such as Figure, Figure, and Figureare detected in each condition, It is normal

  4. Is the measured waveform within specifications?

    YES 

    • Fault is intermittent caused by poor connection in steering sensor harness and/or HECU's connector. Go to Verification Of Vehicle Repair procedure below.

    NO 

    • If STN signal is HIGH on center position, Check for improper installation of steering angle sensor. Repair as necessary and then go to Verification Of Vehicle Repair procedure below.
    • If sensor mounting state is normal, Substitute with a known-good steering angle sensor and check for proper operation.
    • If problem is corrected, replace steering angle sensor and then go to Verification Of Vehicle Repair procedure below.
scientia non olet · About Mike's Workshop Manuals