Repair Procedures: Replacement: Removal

NOTE:

Remove the following items.
- Front pillar trim
  (Refer to "INTERIOR TRIM ")
- Wiper arm
  (Refer to "COWL TOP COVER ")
- Cowl top cover
  (Refer to "COWL TOP COVER ")
Using a screwdriver or remover, remove the windshield glass side molding (A).
Information
- Please use a cutter with a blade length between 8-12 inches.
Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on the edge (B) while pulling the piano wire (A) left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 1: Pulling Piano Wire
Courtesy of HYUNDAI MOTOR AMERICA
If a piano wire is visible inside the chassis, pull the piano wire (A) line inside.

Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on (A-A), (B-B), (C-C), while pulling a piano wire (A) left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 2: Pulling Piano Wire (Left And Right)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the windshield glass (B) carefully using the glass holder (A).

Courtesy of HYUNDAI MOTOR AMERICA