Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Veloster Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System - 1.6L GDI) >> Heated Oxygen Sensor (HO2S) >> Repair Procedures >> Removal >> Notes

Repair Procedures: Removal: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Connector (A), and then remove the Sensor (B).
    NOTE: Note that the SST (Part No.: 09392-2H100) is useful when removing the Heated Oxygen Sensor.
    Fig 1: Identifying SST (09392-2H100)
    G10607948Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals