Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Veloster Turbo, Automatic DCT Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Dual Clutch Transmission Control System - 1.6L T-GDI >> Input Shaft Speed Sensor 2 >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Remove the Air Cleaner Assembly and Air Duct.

    (Refer to: Engine Mechnical System - "AIR CLEANER ").

  2. Remove the Battery and Tray.

    (Refer to: Engine Electrical System - "BATTERY ").

  3. Remove the ECM.

    (Refer to: Engine Control System - "ECM").

  4. Remove the Clutch Actuator Assembly.

    (Refer to Dual Clutch Transmission Control System - "CLUTCH ACTUATOR ASSEMBLY ").

  5. Disconnect the Input Shaft Speed Sensor (A).
    Fig 1: Input Shaft Speed Sensor
    G10607338Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the Input Shaft Speed Sensor after removing the Bolt (A-2EA).
    Fig 2: Input Shaft Speed Sensor Bolts
    G10607339Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Input Shaft Speed Sensor 2
    G10607340Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals