Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) & Sensors >> Passive Occupant Detection System (PODS-F) >> Repair Procedures >> Installation >> PODS-F Mat

PODS-F Mat

  1. Install the PODS-F Mat equipped Seat Cushion Assembly.

    (Refer to: Body procedure - "Seat").

  2. Install the Front Passenger Seat Assembly.

    (Refer to: Body procedure - "Seat").

  3. Connect the PODS-F Mat Connector.
  4. Reconnect the Battery Negative Cable.
  5. After installing the PODS-F, confirm proper system operation:
    1. Turn the Ignition Switch ON the SRS Indicator should be turned on for about six seconds and then go OFF.
    2. Tell-Tale Lamp will turn on for 4 seconds and be turned OFF for 3 seconds. After the 7 seconds, it shall remain OFF if the PODS-F does not require suppression and the Passenger Airbag is enabled.
    NOTE: Be sure to perform PODS-F zeroing with GDS after replacing PODS-F equipped seat cushion.
scientia non olet · About Mike's Workshop Manuals