Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 1.6L T-GDI) >> Intake Air Temperature Sensor (IATS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Manifold Absolute Pressure Sensor Connector (A).
  3. Remove the Installation Bolt (B), and then remove the sensor from the surge tank.
    4. Fig 1: Manifold Absolute Pressure Sensor Connector Installation Bolt
    G00561513Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals