Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 1.6L T-GDI) >> CVVT Oil Control Valve (OCV) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the CVVT Oil Control Valve Connector (A).
  3. Remove the installation Bolt (B), and then remove the Valve from the Engine.

    [Bank 1/Intake] 

    Fig 1: CVVT Oil Control Valve Connector And Installation Bolt (Bank 1/Intake) Location
    G10604609Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 1/Exhaust] 

    Fig 2: CVVT Oil Control Valve Connector And Installation Bolt (Bank 1/Exhaust) Location
    G10604610Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals