Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Dual Clutch Transmission Control System - 1.6L GDI) >> Input Speed Sensor 2 >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Under Cover.
  2. Disconnect the Input Shaft Speed Sensor Connector (a).
    Fig 1: Input Shaft Speed Sensor 2 Connector (1 Of 2)
    G10608144Courtesy of HYUNDAI MOTOR AMERICA
  3. Loosen the Mounting Bolt and remove the Input Shaft Speed Sensor (B).
Fig 2: Input Shaft Speed Sensor 2 (2 Of 2)
G10608145Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals