Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Sonata Plug-In Hybrid >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (PHEV) (1 Of 3) >> DTC P0113: Intake Air Temperature Sensor 1 Circuit High Input >> Component Inspection

Component Inspection

■ Check IATS resistance 

  1. IG "OFF". Disconnect IATS connector.
  2. Measure the resistance between signal terminal and ground terminal of the sensor connector (Component side).

    Specification: 

    Temp. (°C) Resistance (kΩ) Temp. (°C/°F) Resistance (kΩ)
    -40/-40 40.93 ~ 48.35 20/68 2.31 ~ 2.56
    -20/-4 13.89 ~ 16.02 40/104 1.07 ~ 1.20
    0/32 5.38 ~ 6.08 60/140 0.54 ~ 0.06
    10/50 3.48 ~ 3.9 80/176 0.29 ~ 0.33
  3. Is the measured resistance within specification?

    YES 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair " procedure.

    NO 

    • Check IATS for contamination, deterioration, or damage. Substitute with a known-good IATS and check for proper operation. If the problem is corrected, replace IATS and then go to "Verification of Vehicle Repair " procedure.
scientia non olet · About Mike's Workshop Manuals