Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 2.0L (Except HEV)) >> Accelerator Position Sensor (APS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
    Fig 1: Accelerator Position Sensor Connector Location
    G10573381Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the mounting cap (A).
    Fig 2: Mounting Cap Location
    G10573382Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolt (A), and then remove the accelerator pedal module.
    Fig 3: Accelerator Pedal Module Installation Bolt Location
    G10573383Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals