Repair Procedures: Inspection

[Measuring Resistance] 

1. Disconnect the cruise control switch connector from the control switch.
   Fig 1: Locating Cruise Control Switch Connector Terminals

   Courtesy of HYUNDAI MOTOR AMERICA
2. Measure resistance between terminals on the control switch when each function switch is ON. (switch is depressed)

   Function switch	Terminal	Resistance
   SET -	3 - 5	550Ω ± 5%
   RES +	3 - 5	880Ω ± 5%
   CANCEL	3 - 5	330Ω ± 5%
   CRUISE	3 - 5	1.4 kΩ ± 5%

3. If not within specification, replace switch.