Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Santa Fe Sport Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - 2.0L) >> Accelerator Position Sensor (APS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the installation nuts (C), the bolt (B) and then remove the accelerator pedal module.
    Fig 1: Identifying APS Connector And Installation Nuts
    G10582793Courtesy of HYUNDAI MOTOR AMERICA
    Fig 2: Identifying APS Bolt
    G10582794Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals