Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Genesis Coupe 3.8, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle Control System) >> Line Pressure Control Solenoid Vale >> Repair procedures >> Inspection

Repair procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF.
  2. Disconnect the E Module connector.
  3. Measure resistance between valve signal terminal and valve ground terminal.
  4. Check that the resistance is within the specification.
scientia non olet · About Mike's Workshop Manuals