Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Vehicle Parked & Ignition ON.
2. After connecting GDS select "Diagnostic Trouble Codes (DTC)"  Analysis mode.
3. Clear recorded DTC using GDS.
4. Operate the system within DTC "ENABLE CONDITIONS " in "GENERAL INFORMATION ".
5. After selecting "Diagnostic Trouble Codes (DTC)"  mode and check if DTC is recorded again.
6. Are any DTCs recorded?

   YES 

   • Go to the applicable troubleshooting procedure.

   NO 

   • System performing to specification at this time.