Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2016 >> Elantra GT Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Control Module (BCM) Diagnosis >> DTC B1602: CAN Error >> ScanTool Diagnostics >> Monitor ScanTool Data

Monitor ScanTool Data

  1. Connect GDS.
  2. IG "ON" and Engine "OFF".
  3. Select "DTC Analysis" mode.
  4. After erase DTC, keep the vehicle condition within "the Enable Conditions" (Refer to: "DTC DETECTING CONDITION " table).
    Fig 1: Selecting DTC Analysis Mode
    G10752669Courtesy of HYUNDAI MOTOR AMERICA
  5. Is the same DTC occurred again?

    YES 

    • Continue to next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the BCM's connector or was repaired and BCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then proceed to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals