Shift cable alignment Inspection

■ Check the Alignment of Shift Cable 

1. Move TGS lever to "N" position. and unfasten Shift cable - Manual Control Lever nut and Transmission Range sensor 2 bolts.
2. Set Manual Control Lever in "N" position.
   Fig 1: Manual Control Lever And Jig

   Courtesy of HYUNDAI MOTOR AMERICA
3. Insert "N setting Jig (Ø5)" into the "N setting hole"
4. Fasten the Shift cable - Manual Control Lever nut and Transmission Range sensor 2 bolts.

   * Beware of pull or push between Shift Cable and Manual Control Lever.

5. Remove the Jig from "N setting hole"
   Fig 2: Good And Faulty N Alignments

   Courtesy of HYUNDAI MOTOR AMERICA
6. Is the problem solved?

   YES 

   • Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
   • Go to "WIRING INSPECTION " procedure.