Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2015 >> Veloster Turbo, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System - 1.6L GDI) >> Rail Pressure Sensor (RPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Release the residual pressure in Fuel Line (Refer to: "RELEASE RESIDUAL PRESSURE IN FUEL LINE " in this procedure).
    CAUTION: When removing the Fuel Pump Relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the Intake Manifold (Refer to: "Intake And Exhaust System" in EM procedure).
  4. Disconnect the Rail Pressure Sensor Connector (A), and then remove the Sensor (B) from the Delivery Pipe.
    Fig 1: Rail Pressure Sensor And Connector Location
    G10607957Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals