Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2015 >> Veloster Turbo, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System - 1.6L GDI) >> Fuel Tank Pressure Sensor (FTPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Remove the Rear Seat (Refer to: "Seat" in BD procedure).
  3. Remove the Fuel Pump Service Cover (A).
    Fig 1: Fuel Pump Service Cover Location
    G10607964Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the Fuel Tank Pressure Sensor Connector.
  5. Remove the Fuel Tank Pressure Sensor (A) after releasing the Hooks vertically.
    Fig 2: Fuel Tank Pressure Sensor Location
    G10607965Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals