Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2015 >> Veloster Turbo, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System - 1.6L GDI) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Remove the resonator and the Air Intake Hose (Refer to: "Intake And Exhaust System" in EM procedure).
  3. Disconnect the ETC Module Connector (A).
    Fig 1: ETC Module Connector Location
    G10607913Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation Bolts, and then remove the ETC Module (A) from the Engine.
    Fig 2: ETC Module Installation Bolts
    G10607914Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals