Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2015 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 1.6L T-GDI) >> Knock Sensor (KS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Remove the Intake Manifold (Refer to: "Intake And Exhaust System" in EM procedure).
  3. Disconnect the Injector Connector (A).
  4. Remove the Installation Bolt (B), and then remove the sensor from the Cylinder Block.
Fig 1: Injector Connector And Installation Bolt Location
G10604568Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals