Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2015 >> Genesis 5.0 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 3.8L) >> Accelerator Position Sensor (APS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the mounting nut (C) after removing the top cap (B).
  4. Remove the mounting bolt (E) after removing the Lower cap (D).
Fig 1: Accelerator Pedal Top And Lower Caps
G10452271Courtesy of HYUNDAI MOTOR AMERICA
Fig 2: Accelerator Position Sensor Connector And Mounting Nut
G10452272Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals