Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2015 >> Azera Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System Diagnosis >> DTC P0712: Transmission Fluid Temperature Sensor 'A' Circuit Low Input >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Ignition "ON" & Engine "ON".
  3. Select "Current Data" mode and monitor "Oil temperature sensor" parameter.

    Specification:  Increasing Gradually

    Fig 1: Display - Oil Temperature Sensor Normal Data Screen
    G10371381Courtesy of HYUNDAI MOTOR AMERICA
    Fig 2: Display - Oil Temperature Sensor Open Data Screen
    G10371382Courtesy of HYUNDAI MOTOR AMERICA
  4. Is the Oil temperature sensor within specification?

    YES 

    • Fault is intermittent caused by poor contact of PCM/TCM and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "VERIFICATION VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About Mike's Workshop Manuals