Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2015 >> Azera Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System Diagnosis >> DTC P0706: Shift Cable alignment error between TGS Lever and Transmission Range Sensor >> Wiring Inspection >> Power Circuit Inspection

Power Circuit Inspection

  1. Disconnect an Inhibitor switch.
  2. IG KEY "ON" & Engine "OFF".
  3. Measure voltage between supplied power and ground at inhibitor circuit.

    Specification:  Approx. 12V

    Refer to appropriate SYSTEM WIRING DIAGRAM article 

  4. Is the measured voltage within specifications?

    YES 

    NO 

    • Check that ECU fuse-10A is installed or opened.
    • Check circuit open and replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals