Repair Procedures: Replacement: Removal

NOTE:

Remove the following items.
1. Front pillar trim
  (Refer to "INTERIOR TRIM ")
2. Wiper arm
  (Refer to "COWL TOP COVER ")
3. Cowl top cover
  (Refer to "COWL TOP COVER ")
Using a screwdriver or remover, remove the windshield glass side molding (A).
Information
- Please use a cutter with a blade length between 8-12 inches.
Fig 1: Removing Windshield Glass Side Molding
Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on the edge (B) while pulling the piano wire (A) left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 2: Sealant Cutting Position On Edge
Courtesy of HYUNDAI MOTOR AMERICA
If a piano wire is visible inside the chassis, pull the piano wire (A) line inside.

Fig 3: Pulling Piano Wire Line Inside
Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on (A-A), (B-B), (C-C), while pulling a piano wire (A) left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 4: Windshield Glass Sealant Cutting Position
Courtesy of HYUNDAI MOTOR AMERICA
Remove the windshield glass (B) carefully using the glass holder (A).

Fig 5: Removing Windshield Glass
Courtesy of HYUNDAI MOTOR AMERICA