Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - Turbo) >> Crankshaft Position Sensor (CKPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.
    Fig 1: Crankshaft Position Sensor & Connector
    G09151079Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals