Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Cluster Module Diagnosis) >> DTC B1602: CAN Error >> Verification of Vehicle Repair

Verification of Vehicle Repair

WARNING: This page is about a different car, the 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scan tool and select "DTC Analysis" mode.
  2. Clear the DTCs and Operate the vehicle within DTC Enable conditions in General information.
  3. Is any DTC outputted again?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System performing to specification at this time.
scientia non olet · About Mike's Workshop Manuals