Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Tire Pressure Monitoring System (TPMS)) >> TPMS Sensor >> Repair procedures >> Replacement >> When The TPMS Warning Lamp OFF

When The TPMS Warning Lamp OFF

WARNING: This page is about a different car, the 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the TMK repaired tire, wheel and TPMS sensor.

    (Refer to REMOVAL "Tire removal")

  2. Remove the sealant on the wheel and TPMS sensor (A) completely.
    CAUTION:
    • Clean the sealant on the housing and sensing hole of TPMS sensor with clean cloth, gauze or air inhalers.
    • To prevent the sensor and circuit board damage, do not use the pointed instrument and give a lot of impact.
    Fig 1: Identifying TPMS Sensor
    G09137687Courtesy of HYUNDAI MOTOR AMERICA
  3. Install the TPMS sensor to the new tire.
  4. Check that the normal operation of TPMS system.
scientia non olet · About Mike's Workshop Manuals