Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Tire Pressure Monitoring System (TPMS)) >> TPMS Receiver >> Repair procedures >> Replacement >> Notes

Repair procedures: Replacement: Notes

WARNING: This page is about a different car, the 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When the receiver first arrives for replacement:
  1. It will be in Virgin State.
  2. It will not be configured for any specific platform.
  3. It will not have any sensor ID's memorized.
CAUTION: It is important to make sure that the correct receiver is used to replace the faulty part i.e. it must be Low Line in order to have the correct inflation warning thresholds set.
  1. Disconnect vehicle battery.
  2. Remove the glove box.

    (Refer to "CRASH PAD ")

  3. Remove faulty part and fit bracket assembly to new part.
    Fig 1: Identifying Bracket Assembly And Bolt
    G09137690Courtesy of HYUNDAI MOTOR AMERICA
  4. Secure new part to vehicle and fit connector.
  5. Re-connect battery and turn Ignition on.
  6. Check that TREAD Lamp flash rate matches Virgin State indication.
  7. After replacing the receiver, learn by using self-diagnosis device (GDS).
scientia non olet · About Mike's Workshop Manuals