Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Control System - Non-Turbo) >> ETC (Electronic Throttle Control) System >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2013 Hyundai Veloster and 2012 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the resonator and the air intake hose (Refer to "Intake And Exhaust System ").
  3. Disconnect the ETC module connector (A).
    Fig 1: Identifying ETC Module Connector
    G08807012Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolts, and then remove the ETC module (A) from the engine.
    Fig 2: Identifying ETC Module
    G08807013Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals