Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Control System - Non-Turbo) >> ETC (Electronic Throttle Control) System >> Repair procedures >> Adjustment >> ETC module learning procedure

ETC module learning procedure

WARNING: This page is about a different car, the 2013 Hyundai Veloster and 2012 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

When installing new ETC module or re-installing it, ETC module learning procedure must be performed.

  1. Hold the ignition key or the start button at th IG ON position during 5 seconds.
  2. Turn ignition swich OFF and then start the engine.
    CAUTION: DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.
scientia non olet · About Mike's Workshop Manuals