Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Control System - Non-Turbo) >> CVVT Oil Control Valve (OCV) >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2013 Hyundai Veloster and 2012 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the CVVT oil control valve connector (A).
  3. Remove the installation bolt (B), and then remove the valve from the engine.

    [Bank 1/Intake] 

    Fig 1: Identifying CVVT Oil Control Valve Connector And Installation Bolt (Bank 1 / Intake)
    G08807082Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 1/Exhaust] 

    Fig 2: Identifying CVVT Oil Control Valve Connector And Installation Bolt (Bank 1 / Exhaust)
    G08807083Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals