Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) - Non-Turbo >> DTC P0112: Intake Air Temperature Sensor 1 Circuit Low Input >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC)
  2. IG KEY "ON" & ENG "OFF".
  3. Monitor the "IATS" parameters on the GDS.
    Fig 1: Display - IATS Parameters
    G08813486Courtesy of HYUNDAI MOTOR AMERICA
  4. Is the "IATS" parameter displayed correctly?

    YES 

    Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    Go to "TERMINAL & CONNECTOR INSPECTION " procedure.

scientia non olet · About Mike's Workshop Manuals