Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Smart Key Unit Diagnosis) >> DTC B1602: CAN Error >> Verification of Vehicle Repair

Verification of Vehicle Repair

WARNING: This page is about a different car, the 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode.
  2. Clear DTC using a scantool.
  3. Drive the vehicle within DTC Enable conditions in General information.
  4. After selecting "Diagnostic Trouble Codes (DTCs)" mode and check DTC is recorded again.
  5. Are any DTCs recorded?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System is performing to specification at this time.
scientia non olet · About Mike's Workshop Manuals