Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Smart Key Unit Diagnosis) >> DTC B1602: CAN Error >> General Information >> DTC Detecting Condition

General Information: DTC Detecting Condition

WARNING: This page is about a different car, the 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
Item Detecting Condition Possible Cause
DTC Strategy
  • CAN Signal Check
  1. Driver door opens, No sleeping mode in Smartkey Unit
    1. Open or short circuit in CAN High line
    2. Open or short circuit in CAN Low line
    3. Short circuit in CAN High and Low circuit
  2. Note Signal level in sleeping mode
    • CAN High line: low
    • CAN Low line: high
Enable Conditions
  • Battery voltage applied to Smartkey Unit
    1. Short to battery in CAN High/Low circuit
    2. Short to ground in CAN High/Low circuit
    3. Short circuit between CAN High and CAN Low each other
    4. Short to B+ (5V) in CAN High circuit
    5. Open in CAN High/Low circuit
Threshold value
  • CAN High/Low: Voltage is "0" means short to ground, Voltage is "B+" means short to battery
Diagnostic Time
  • Above 2 sec.
DTC Erasing Time
  • Immediately
scientia non olet · About Mike's Workshop Manuals