Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Tucson GLS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Automatic Transaxle Control System - 2.4L) >> Line Pressure Control Solenoid Valve >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF.
  2. Remove the air duct.

    (Refer to AIR CLEANER )

  3. Disconnect the solenoid valve connector (A).
    Fig 1: Disconnecting Solenoid Valve Connector
    G09802532Courtesy of HYUNDAI MOTOR AMERICA
  4. Measure resistance between sensor signal terminal and sensor ground terminal.
  5. Check that the resistance is within the specification.
scientia non olet · About Mike's Workshop Manuals