Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Tucson GLS, FWD >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Axle Assembly >> Front Hub/Knuckle/Tone Wheel >> Repair Procedures >> Disassembly

Repair Procedures: Disassembly

  1. Using the snap ring pliers, remove the snap ring (A).
    Fig 1: Removing Snap Ring Using Snap Ring Pliers
    G06875116Courtesy of HYUNDAI MOTOR CO.
  2. Remove the hub assembly from the knuckle assembly.
    1. Install the front knuckle assembly (A) on press.
    2. Lay a suitable adapter (B) upon the hub assembly shaft.
      Fig 2: Removing The Hub From Knuckle Assembly
      G06875117Courtesy of HYUNDAI MOTOR CO.
  3. Remove the dust cover (A).
    Fig 3: Dust Cover
    G06875118Courtesy of HYUNDAI MOTOR CO.
  4. Remove the hub bearing inner race from the hub assembly
    1. Install a suitable tool (A) for removing the hub bearing inner race on the hub assembly.
    2. Lay the hub assembly and tool (A) upon a suitable adapter (B).
    3. Lay a suitable adapter (C) upon the hub assembly shaft.
    4. Remove the hub bearing inner race (D) from the hub assembly by using press.
      Fig 4: Removing Hub Bearing Inner Race From Hub Assembly Using Press
      G06875119Courtesy of HYUNDAI MOTOR CO.
  5. Remove the hub bearing outer race from the knuckle assembly.
    1. Lay the hub assembly (A) upon a suitable adapter (B).
    2. Lay a suitable adapter (C) upon the hub bearing outer race.
    3. Remove the hub bearing outer race from the knuckle assembly by using press.
      Fig 5: Removing Hub Bearing Outer Race From Hub Assembly Using Press
      G06875120Courtesy of HYUNDAI MOTOR CO.
  6. Replace hub bearing with a new one.
scientia non olet · About Mike's Workshop Manuals