Control Circuit Inspection

IG "OFF" & Disconnect FPR connector.
IG "ON" & ENG "OFF".
Measure the voltage between FPR open, FPR close terminal of FPR (B1) harness connector and chassis ground.
Specification:

FPR open Terminal: Approx. 0~0.6V

FPR close Terminal: Approx. 0.6V
Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Check for Open or Short in FPR circuit. Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.