Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Elantra SE, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Cluster Module Diagnosis) >> DTC B1602: CAN Error >> Scantool Diagnostics >> Monitor Scantool Data

Monitor Scantool Data

WARNING: This page is about a different car, the 2013 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "DTC Analysis" mode.
  4. After erase DTC, keep the vehicle condition within "the enable conditions" (Refer to "DTC DETECTING CONDITION " table).
    Fig 1: Scantool Display - CAN Error
    G10246033Courtesy of HYUNDAI MOTOR AMERICA
  5. Is the same DTC occurred again?

    YES 

    • Go to next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the CLU's connector or was repaired and CLU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals