Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2014 >> Accent GLS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Airbag Modules & Clock Spring) >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2012 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Install a Curtain Airbag (CAB) on the mounting bracket.
  4. Tighten the CAB mounting bolts (10EA).

    Tightening torque 

    : 1.1 ~ 1.5 kgf.m (10.9 ~ 14.7 Nm, 8.0 ~ 10.8 lb.ft)

    CAUTION:
    • Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
  5. Connect the CAB connector.
  6. Install the following parts. (Refer to INTERIOR TRIM .)
    1. Side trim, Roof trim
  7. Reconnect the battery negative cable.
  8. After installing the Curtain Airbag (CAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About Mike's Workshop Manuals