Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2013 >> Veloster Turbo, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - Non-Turbo) >> Rail Pressure Sensor (RPS) >> Repair procedures >> Installation

Repair procedures: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  1. Installation is reverse of removal.

    Rail Pressure Sensor Installation: 

    29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

scientia non olet · About Mike's Workshop Manuals