Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2013 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - Turbo) >> Manifold Absolute Pressure Sensor (MAPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the manifold absolute pressure sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor from the surge tank.
    Fig 1: Manifold Absolute Pressure Sensor Connector & Bolt
    G09151056Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals