Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2013 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - Turbo) >> Purge Control Solenoid Valve (PCSV) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the purge control solenoid valve connector (A).
  3. Disconnect the vapor hoses (B) from the purge control solenoid valve.
  4. Remove the installation bolt (C), and then remove the PCSV (D) from the engine.
    Fig 1: Purge Control Solenoid Valve Connector, Vapor Hoses, Bolt & PCSV
    G09151127Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals