Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2013 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - Turbo) >> Canister Close Valve (CCV) >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF.
  2. Disconnect the CCV connector.
  3. Measure resistance between the CCV terminal 1 and 2.
  4. Check that the resistance is within the specification.

    Specification  : Refer to "Specifications "

  5. Disconnect the vapor hose connected with the canister from the CCV.
  6. Connect a vacuum pump to the nipple.
  7. Ground the CCV control line and apply battery voltage to the CCV power supply line.
  8. Apply vacuum and check the valve operation.

    Specification  : Vacuum maintained

scientia non olet · About Mike's Workshop Manuals