Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2013 >> Tucson GL, Standard Trans >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle System >> Repair Procedures (M5GF1) >> Service Adjustment Procedure >> Back Up Lamp Switch Inspection

Back Up Lamp Switch Inspection

  1. Disconnect the back up lamp switch connector (A).
    Fig 1: Identifying Back Up Lamp Switch Connector
    G06874944Courtesy of HYUNDAI MOTOR CO.
  2. Inspect the continuity of the switch. When the shift lever is located in reverse range, it should be applied an electric current.
  3. Replace the back up lamp switch, if necessary.

    Tightening torque: 

    29.4~34.4 N.m (3.0~3.5 kgf.m, 21.7~25.3 lb-ft)

scientia non olet · About Mike's Workshop Manuals