Transmitter Code Registration (Using GDS)

Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS.

Fig 1: Locating Data Link Connector
Courtesy of HYUNDAI MOTOR AMERICA
Select the vehicle model and then do "CODE SAVING"

Fig 2: Display - Transmitter Code Saving Selection Screen
Courtesy of HYUNDAI MOTOR AMERICA
After selecting "CODE SAVING" menu, button "ENTER" key, then the screen will be shown as below.

Fig 3: Display - Code Saving Menu Screen
Courtesy of HYUNDAI MOTOR AMERICA
After removing the ignition key from key cylinder, push "ENTER" key to proceed to the next mode for code saving. Follow steps 1 to 4 and then code saving is completed.

Fig 4: Display - Code Saving Completed Screen
Courtesy of HYUNDAI MOTOR AMERICA

Fig 5: Display - First Transmitter Saved Screen
Courtesy of HYUNDAI MOTOR AMERICA

Fig 6: Display - Code Saving Completed Screen
Courtesy of HYUNDAI MOTOR AMERICA

Fig 7: Display - Second Transmitter Saved Screen
Courtesy of HYUNDAI MOTOR AMERICA

Fig 8: Display - Code Saving Completed Screen
Courtesy of HYUNDAI MOTOR AMERICA

Fig 9: Display - Third Transmitter Saved Screen
Courtesy of HYUNDAI MOTOR AMERICA

Fig 10: Display - Code Saving Completed Screen
Courtesy of HYUNDAI MOTOR AMERICA

Fig 11: Display - Fourth Transmitter Saved Screen
Courtesy of HYUNDAI MOTOR AMERICA

Fig 12: Display - Code Saving Completed Screen
Courtesy of HYUNDAI MOTOR AMERICA