Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Hyundai >> 2013 >> Genesis 3.8 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - 5.0L) >> Fuel Tank Pressure Sensor (FTPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the fuel pump service cover (A).
    Fig 1: Identifying Fuel Pump Service Cover
    G08822900Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the fuel tank pressure sensor connector (A).
  4. Remove the fuel tank pressure sensor after remove the installation botl (B).
    Fig 2: Identifying Fuel Tank Pressure Sensor Connector And Installation Bolt
    G08822901Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals